CF-H2 GPS KIT
- Installation instructions








- - -

1. Disconnect AC-adapter.

2. Remove both batteries.

3. Remove harddrive (4 screws).





4. Remove LAN/RS232 port cover (2 screws).






5. Remove screws holding back cover (13+2 screws).


2 screws are located inside the hardrive bay.


One screw is located inside the power port cover.


...and one screw is located inside the USB port cover.


6. Remove back cover, lifting up at the bottom first.




7. Install the GPS module, and place nylon washers over the two top holes .


8. Fold the stainless steel antenna platform as shown.


9. Install stainless steel platform and antenna
(fix antenna to platform using the 3M pad).


10. Connect antenna to GPS, and GPS to mainboard.

11. Put the computer back together.

12. Enter BIOS and enable the GPS.

13. Download U-Center here
Use this utility to monitor and configure your GPS.


- - -



This product was added to our catalog on Tuesday 20 August, 2013.

Your IP Address is: 107.22.46.150
Copyright © 2017 Custom Toughbooks. Powered by Zen Cart