CF-H1 GPS KIT
- Installation instructions








- - -

1. Disconnect AC-adapter.

2. Remove both batteries.

3. Remove harddrive (2 screws).


4. Remove screws holding back cover (13+2 screws).


Two screws are located inside the harddrive bay.


One screw is located inside the power port cover.


5. Remove back cover,
lifting up at the bottom right corner first (as seen from behind).




6. Install GPS module, and place nylon washers over the two top holes .


7. Fold the stainless steel antenna platform as shown.


8. Install stainless steel platform and antenna
(fix antenna to platform using the 3M pad).


9. Connect antenna to GPS,
and GPS to mainboard (mainboard connector CN1002).

10. Put the computer back together.

11. Enter BIOS and enable the GPS.

12. Download U-Center here
Use this utility to monitor and configure your GPS.


- - -



This product was added to our catalog on Tuesday 20 August, 2013.

Your IP Address is: 54.90.92.204
Copyright © 2017 Custom Toughbooks. Powered by Zen Cart