- Installation instructions

- - -

1. Disconnect AC-adapter.

2. Remove battery.

3. Remove bottom panel, 17 screws (11 + 6).

4. Install GPS module using the included wafer head screws.

5. Insert FFC (flat cable) into mainboard connector.

6. Insert other end into GPS module.

7. Remove WWAN antenna cover (RH side).

8. Remove RH plastic LCD corner cover, 4 screws.

9. Remove keyboard bezel, 3 screws.

10. Remove RH hinge cover, 2 screws.
Also remove the cable-through cover, 2 screws.

11. Install antenna. Fix with non-padded double sided tape.

12. Run the antenna cable through the hinge as shown, and down into the base.

13. Connect antenna to the GPS module.

14. Remove the strip of plastic underneath the LCD corner cover as shown below to make room for the antenna.

15. Put the machine back together.

16. Enter BIOS and enable the GPS. The GPS option is found on the "Advanced" tab, under "Serial Port Settings"

- - -

This product was added to our catalog on Monday 23 July, 2012.

Your IP Address is:
Copyright © 2017 Custom Toughbooks. Powered by Zen Cart